* configure.ac: re-sort Kdrive libs so that symbols get properly resolved.
Basically, all some libs are present in both $KDRIVE_LIBS and $XSERVER_LIBS,
and some libs orders are not correct. So I made sure Kdrive servers don't have
to link against $KDRIVE_LIBS *and* $XSERVER_LIBS. They just have to link
against $KDRIVE_LIBS now.
* hw/kdrive/*/Makefile.am: update those makefile to reflect the change in configure.ac
Convert KDrive to GPE/GKE interface.
Add first-class drivers and enumerate every device separately through
Xi, instead of lamely attempting to aggregate them.
Add XKB support to the Linux keyboard driver.
Add 'thumb button' support to the tslib driver.
Rejig InitInput, so each DDX has to add a list of drivers it supports.
Support NewInputDeviceRequest, et al.
in the kaa structure: markSync and waitMarker. The first, if set,
returns a hardware-dependent marker number which can then be waited for
with waitMarker. If markSync is absent (which is the case on all
drivers currently), waitMarker must wait for idle on any given marker
number. The intention is to allow for more parallelism when we get
downloading from framebuffer, or more fine-grained idling.
- Replace the KdMarkSync/KdCheckSync functions with kaaMarkSync and
kaaWaitSync. These will need to be refined when KAA starts being smart
about using them. Merge kpict.c into kasync.c since kasyn.c has all the
rest of these fallback funcs.
- Restructure all drivers to initialize a KaaInfo structure by hand rather
than statically in dubious order.
- Whack the i810 driver into shape in hopes that it'll work after this
change (it certainly wouldn't have before this). Doesn't support my
i845 though.
- Make a new KXV helper to avoid duplicated code to fill the region with
the necessary color key. Use it in i810 and mach64 (tested).
but includes debugging to ensure that the reg being submitted is the
one that follows in the packet. Convert most uses of OUT_RING to it,
and convert a couple of OUT_REG sets to DMA_PACKET0/OUT_RING_REG. Also,
add checking to see if more registers are submitted to a DMA_PACKET0
than should be, to avoid hangs during stupid mistakes (checking for
less isn't done).
reading a register/attempting DMA. Now it'll wait for a certain number
of seconds rather than a certain number of times through the loop
before deciding that it's timed out and resetting the hardware. Also,
add more timeout handling, and reset the draw state after resetting the
engine.
are always emitted. Fix the real problem, which was not enough regs
being initialized in ati_draw.c. Fix a typo that was resulting in alpha
coming out as 0 * src or 0 * broken instead of src * 1 or src * mask.
Assign the blending results to R0, as appears to be necessary. Unbreak
the dst-alpha-blend-with-no-dst-alpha code. Yow. And set the right DMA
count for the r200 traps code.
non-mask rendering. Reenable it. Also, R200TexFormats was used instead
of R100 in one place. Harmless so far, because the formats were in the
same order.
